Checking wiring and sensors

Check the power supply cable between transmission control module (TCM) terminal 57A and vehicle speed sensor (VSS) connector terminal 1 for an open-circuit according to Open-circuit, permanent faults .

Check the signal cable between transmission control module (TCM) terminal 39A and vehicle speed sensor (VSS) connector terminal 2 for an open-circuit according to Open-circuit, permanent faults .

HINT: With the control module connected, the ignition on and a voltmeter connected between vehicle speed sensor (VSS) connector terminals 1 and 2 (control module side), the voltage should be approximately 1 V under Ubat. 

Remedy as necessary.

Other information: 

• To connect the breakout box, see Connecting breakout box, Transmission control module (TCM) .
• To disconnect the transmission control module (TCM), see Replacing the gearbox control module (TCM) .
• To check/replace the vehicle speed sensor (VSS), see Replacing vehicle speed sensor (VSS) .
• For information about signals, see Signal specification, Transmission control module (TCM) .

Fig 2: Identifying Vehicle Speed Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Automatic Transmission Control Module (TCM)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to Verification