Brake Control System - Overhaul Instructions (Convertible)
- Abs Wheel Sensor Wiring -January 1996 (1998-1999)
- ABS wheel sensor wiring -Jan 1996 (natural gas powered engines)
- Description
- Preparations:
- Remove electrical distribution unit cover (4 torx)
- Remove all relays in terminals 201 - 215
- Remove cable harness covers
- Remove fuse panel (3 screws)
- Identify two spliced cable pairs (4 cable slices)
- Cut one cable pair
- Joining:
- Cut cable splice on both cables
- Splice the same cable ends that were previously spliced.
- Take the crimping tool with crimping sleeve to the car
- When one cable pair has been spliced, cut and splice the remaining cable pair
- Installing heat-shrink tubing on cable splice
- Reinstall central electrical unit
- Remove screw and pull up black box
- Install relays
- Press the black box into place
- Install a tie strap on the auxiliary cable duct (at A, instead of the tape)
- Finishing
- Checking ABS system after repair
- ABS wheel sensor wiring -January 1996
- Description
- Replacing wiring (not natural gas powered cars)
- Joining
- Cut cable splice on both cables
- Splice the same cable ends that were previously spliced.
- Take the crimping tool with crimping sleeve to the car
- When one cable pair has been spliced, cut and splice the remaining cable pair
- Installing heat-shrink tubing on cable splice
- Checking ABS system after repair
- ABS wheel sensor wiring -Jan 1996 (natural gas powered engines)
- Front Brake Caliper, Repair (1998-2004)