LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1996 >> 960 4D Wagon, AW30-43 >> Repair and Diagnosis >> Steering >> Steering Column >> Removal & Installation >> Steering Column >> Installation

Steering Column: Installation

  1. Connect ignition switch connector. Install bearing housing with steering lock, but do not tighten retaining bolts. Install spring and washer on steering column. Install steering column through bulkhead.
  2. Turn ignition key to "I" position. Press steering column into bearing housing. Install spacer ring and locking ring on steering shaft. Ensure locking ring is flush in groove. Tighten bearing housing retaining bolts.
  3. Install lower steering shaft. Torque bolts to 18 ft. lbs. (24 N.m) and install locking pin. Ensure steering and steering lock operate correctly. Remove shear bolts and bolt on steering pin. To complete installation, reverse removal procedure.
  4. Reactivate SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Check SRS warning light to ensure system is functioning properly. If air bag warning light stays on, see appropriate article:
    • AIR BAG RESTRAINT SYSTEM - 1995.
    • AIR BAG RESTRAINT SYSTEM - 1996.
scientia non olet · About LEMON Manuals