Removal & Installation
WARNING: This page is about a different car, the 1995 Volvo 850. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect negative battery cable. Clean area around control module connector, then disconnect connector. Remove 3 screws and carefully lift control module from vehicle. See Fig 1 .
- To install, reverse removal procedure. Tighten control module screws to 48 INCH lbs. (5 N.m). Reconnect electrical connector and negative battery cable. Check for DTCs, ensuring DTC 1-1-1 is displayed.