Piston Cooling Nozzle Control Valve - N522-, Checking

General Description

The Piston Cooling Nozzle Control Valve -N522- is ground side switched by the Engine/Motor Control Module - J623-. It has fused power to it with the ignition on.

Special tools and workshop equipment required

Multimeter.
Wiring Diagram.
Scan Tool.

Test requirements

Fuses OK.
Battery voltage OK.
Switch OFF all electrical and electronic accessories.
Vehicles with automatic transmission, ensure the selector lever position is in "P".
Vehicles with manual transmission, ensure the shifter lever position is in "N" with the parking brake applied.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 Piston Cooling Nozzle Control Valve - N522-, CHECKING => 2 . -- NO: GATHER more information from customer about the complaint.
2	IGNITION: ON. CHECK: Piston Cooling Nozzle Control Valve -N522- harness connector terminal 2 to ground for voltage. SPECIFIED VALUE: Battery voltage. IGNITION: OFF. -- Was Value obtained?	-- YES: GO TO: Step 3 Piston Cooling Nozzle Control Valve - N522-, CHECKING => 3 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 4 Piston Cooling Nozzle Control Valve - N522-, CHECKING => 4 .
3	REMOVE: Engine/Motor Control Module - J623-. Refer to appropriate Service Information. CHECK: Piston Cooling Nozzle Control Valve -N522- harness connector terminal 1 to the Engine/Motor Control Module - J623- harness connector T105 / 6 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Was Value obtained?	-- YES: TIP: The Piston Cooling Nozzle Control Valve -N522- may fail under loaded operation; please swap a known good Piston Cooling Nozzle Control Valve -N522- prior to continuing to the next step. GO TO: Step 4 Piston Cooling Nozzle Control Valve - N522-, CHECKING => 4 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 4 Piston Cooling Nozzle Control Valve - N522-, CHECKING => 4 .
4	Final Procedure Perform a road test to verify repair. -- Does the original DTC return?	-- YES: CHECK: Engine/Motor Control Module -J623- harness connector for any damaged, pushed-out pins. REPAIR: As necessary. If all electrical connections are OK: REPLACE: Engine/Motor Control Module -J623-. Refer to appropriate Service Information. Clear the DTC's. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY . Repair is complete. Generate Readiness Code. Refer to READINESS CODE . Return vehicle to Customer. -- NO: Perform the diagnostic procedure for any DTC's. If no DTC's return, the repair is complete. Return vehicle to customer.