Guidelines For Clean Working Conditions

WARNING: This page is about a different variant/trim than selected.

Thoroughly clean the connection points and the surrounding area before loosening.
Place the removed parts on a clean surface and cover them. Use foil and paper. Use a lint-free cloth.
Carefully cover or seal opened components if the repair will not be done immediately.
Only install clean parts: remove the replacement parts from their packaging just before installing them.
Always replace seals and gaskets.
Coat the O-rings with ATF before inserting to prevent the rings from being crushed during assembly.
After installing, check the ATF level and fill if necessary. Refer to ATF LEVEL, CHECKING .