Diagnostic Mode 09 - Request Vehicle Information
Diagnostic Mode 09 makes it possible to access vehicle specific information from the control modules (where applicable).
NOTE:
Depending on the scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.
Test Requirement
- No DTCs stored in the DTC memory.
Procedure
-- Connect the scan tool.
-- Switch the ignition on.
-- Select Mode 09: Vehicle information.
-- Select the desired Test ID.
-- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all Test IDs that may be selected.
| Test-ID | Diagnostic text |
|---|---|
| 02: | Vehicle Identification Number (VIN) e.g. |
|
|
| 04: | Calibration Identification (ID) e.g. |
|
|
|
|
| 06: | Calibration Verification Number (CVN) (check sum) e.g. |
|
|
|
|
| 08: | In-use Performance Tracking |
| 0A: | ECU Module Acronym And Text Name |
|
|
| $13: | Certification Test Group, Engine Family Number |
| $14: | Distance Traveled Since Evap Monitoring Decision |
| $16: | Vehicle Operation Data - Engine Run/Idle Time |
| $17: | Vehicle Operation Data - Distance/Fuel Used |
| $18: | Vehicle Operation Data - PKE/EOE |
| $19: | Vehicle Operation Data - PSA |
| $1D: | Active Aerodynamic Features #1 Off-cycle Credit Vehicle Data |
| $22: | Run Time for Stop-Start and Coasting Off-Cycle Credit Vehicle Data |
| $24: | Active Powertrain Warm-up Features Off-cycle Credit Vehicle Data |
-- Switch the ignition off.