MULTIFUNCTION Transmission Range Switch, Adjusting
Special tools and workshop equipment required
- Gauge - Multi Function Switch: T10173
-- Move the selector lever into "N".
-- Do not bend the selector lever cable.
Adjustment Requirements:
- The selector lever cable is removed from the selector lever.
- The selector shaft is in "N".
- The bolts are loosened from the Multifunction Transmission Range Switch -F125-
- The selector lever is removed from the front selector shaft
-- Install the : T10173 on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the : T10173 locks onto the tab on the connector on the Multifunction Transmission Range Switch -F125-.
If the connector tab cannot engage into the : T10173 groove, then the transmission is no longer in "N". If this is the case, shift the transmission into "N" using the : T10173 .
-- Use the bolt -3- to secure the : T10173 to the selector shaft -2-.
-- Tighten the bolts -arrows- to the tightening specification.
-- Remove the : T10173 .
-- Further installation is performed in reverse order of removal. Refer to Multifunction Transmission Range Switch -F125-, Installing .
Tightening Specifications
| Component | Nm |
|---|---|
| Multifunction Transmission Range Switch -F125- to transmission | 6 |