Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle: Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
NOTE:
If the engine does not start, crank the engine using starter for at least 5 seconds. Do not switch the ignition off afterward.
-- Select Mode 7: Check test results of components that are continuously monitored.
The number of pending DTCs or 0 malfunctions detected will be displayed on the scan tool screen.
-- Refer to the following DTC tables for the diagnostic repair procedures.
- ENGINE DTC TABLES, 2016 MY and ENGINE DTC TABLES, 2017 MY
- TRANSMISSION DTC TABLES, 2016 MY and TRANSMISSION DTC TABLES, 2017 MY
-- Switch the ignition off.