| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to: PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- IGNITION: OFF.
- DISCONNECT: Intake Manifold Runner Control Valve -N316- harness connector.
- CHECK: Intake Manifold Runner Control Valve -N316- component connector terminals 1 to 2 for resistance.
- SPECIFIED VALUE: 5 - 35 Ω (@ approx. 20° C).
-- Was Value obtained? |
-- YES:
-- NO:
|
| 3 |
- IGNITION: ON.
- CHECK: Intake Manifold Runner Control Valve -N316- harness connector terminal 1 to ground for voltage.
- SPECIFIED VALUE: Battery voltage.
- IGNITION: OFF.
-- Was Value obtained? |
-- YES:
-- NO:
|
| 4 |
- REMOVE: Engine Control Module - J623-.
- CHECK: Intake Manifold Runner Control Valve -N316- harness connector terminal 2 to the Engine Control Module - J623- harness connector T105 / 53 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Was Value obtained? |
-- YES:
-- NO:
|
| 5 |
- Final Procedure
- Perform a road test to verify repair.
-- Does the original DTC return? |
-- YES:
- CHECK: Engine Control Module -J623- harness connector for any damaged, pushed out pins.
- REPAIR: As necessary.
- If all electrical connections are OK:
- REPLACE: Engine Control Module -J623-.
- Clear the DTC's. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY
.
- Repair is complete. Generate Readiness Code. Refer to READINESS CODE
.
- Return vehicle to Customer.
-- NO:
- Perform the diagnostic procedure for any DTC's.
- If no DTC's return the repair is complete.
- Return vehicle to customer.
|