Steering Gear, Hydraulic Steering Gear, Servicing: Notes

Fig 1: Exploded View Of Power Steering Gear, Hydraulic Steering Gear Assemble

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Right Tie Rod End
   • Identified with "A". Refer to Installing  - Make Sure The Correct Tie Rod End Is Installed On Each Side  .
   • Removing and installing. Refer to TIE ROD END, REMOVING AND INSTALLING .
   • Checking. Refer to Checking Play, Fastening and Joint Boots of Tie Rod Ends 
   • Installed position. Refer to Installing  - Make Sure The Correct Tie Rod End Is Installed On Each Side  .
2. Nut
   • 70 Nm
3. Clamp
4. Boot
   • Must not be twisted after toe is adjusted
   • To replace, remove steering gear
5. Clamp
   • Always replace
   • Tensioning. Refer to Installing  - Tighten The New Clamp Using The :VAS6199 To The Extent Depicted In The Illustration  .
6. Right Tie Rod
   • 100 Nm
   • Removing and installing. Refer to HYDRAULIC STEERING GEAR TIE ROD, REMOVING AND INSTALLING .
   • Is preset when supplied as replacement part
7. Power Steering Gear
   • For the allocation refer to the parts information.
   • Removing and installing. Refer to STEERING GEAR, HYDRAULIC STEERING GEAR, REMOVING AND INSTALLING .
8. Left Tie Rod End
   • Identified with "B". Refer to Installing  - Make Sure The Correct Tie Rod End Is Installed On Each Side  .
   • Removing and installing. Refer to TIE ROD END, REMOVING AND INSTALLING .
   • Checking. Refer to Checking Play, Fastening and Joint Boots of Tie Rod Ends 
   • Installed position. Refer to Installing  - Make Sure The Correct Tie Rod End Is Installed On Each Side  .