Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | WORKING WITH A/C SERVICE STATION (1 OF 2) and WORKING WITH A/C SERVICE STATION (2 OF 2) | ||
| Torque | OVERVIEW - A/C COMPRESSOR | ||
| Axle Nut/Hub Nut | |||
| Front | 200 Nm +180° | ||
| Rear | 200 Nm + 90° | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | HYDRAULIC SYSTEM | ||
| Disc Brakes | |||
| Torque | OVERVIEW - FRONT BRAKES OVERVIEW - REAR BRAKES |
||
| Charging | |||
| Generator | N/A | ||
| Torque | |||
| Drive Belts | |||
| Adjustment | |||
| 1.8L (CPRA) | RIBBED BELT, REMOVING AND INSTALLING | ||
| 2.0 (DDSA) | RIBBED BELT, REMOVING AND INSTALLING | ||
| Belt Routing | |||
| 1.8L (CPRA) | Refer to figure under Installing | ||
| 2.0L (DDSA) | Refer to figure under Installing | ||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | |||
| 1.8L Engine Code(s): CPRA | 1.6 to 1.8 bar (23.2 to 26.1 psi) | ||
| 2.0L Engine Code(s): DDSA | 1.4-1.6 Bar (20.3 to 23.2 psi) | ||
| Thermostat R & I | |||
| 1.8L (CPRA) | COOLANT THERMOSTAT HOUSING, REMOVING AND INSTALLING | ||
| 2.0L (DDSA) | COOLANT THERMOSTAT HOUSING, REMOVING AND INSTALLING | ||
| Water Pump R & I | |||
| 1.8L (CPRA) | COOLANT PUMP, REMOVING AND INSTALLING | ||
| 2.0L (DDSA) | COOLANT PUMP, REMOVING AND INSTALLING | ||
| Engine Mechanical | |||
| 1.8L (CPRA) | |||
| Compression | COMPRESSION, CHECKING | ||
| Oil Pressure | OIL PRESSURE, CHECKING | ||
| Overhaul | 10 ENGINE ASSEMBLY 13 CRANKSHAFT, CYLINDER BLOCK 15 CYLINDER HEAD, VALVETRAIN |
||
| Torque | Refer to the appropriate procedure in 10 ENGINE ASSEMBLY , 13 CRANKSHAFT, CYLINDER BLOCK and 15 CYLINDER HEAD, VALVETRAIN | ||
| 2.0L (DDSA) | |||
| Compression | COMPRESSION, CHECKING | ||
| Oil Pressure | OIL PRESSURE, CHECKING | ||
| Overhaul | 10 ENGINE ASSEMBLY 13 CRANKSHAFT, CYLINDER BLOCK 15 CYLINDER HEAD, VALVETRAIN |
||
| Torque | Refer to the appropriate procedure in 10 ENGINE ASSEMBLY , 13 CRANKSHAFT, CYLINDER BLOCK and 15 CYLINDER HEAD, VALVETRAIN | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Engine Oil Drain Plug | 30Nm | ||
| Flywheel/Flex Plate Torque | 60 Nm + 90° | ||
| Fuel System | |||
| Fuel Pressure Test Procedure | |||
| 1.8L (CPRA) | FUEL PRESSURE, CHECKING | ||
| 2.0L (DDSA) |
N/A |
||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | |||
| 1.8L (CPRA) | 06K 905 601 D | ||
| 2.0L (DDSA) | 06K 905 601 D | ||
| Starting | |||
| Starter | STARTER | ||
| Torque | OVERVIEW - STARTER | ||
| Wheel Alignment | |||
| Adjustment Specifications | AXLE ALIGNMENT | ||
| Torque | Refer to the appropriate procedure in 40 FRONT SUSPENSION 42 REAR SUSPENSION |
||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 103 Ft. Lbs (140 Nm) | ||