Power Steering Fluid Level, Checking: Procedure
-- Remove the cap from the reservoir.
-- Wipe dipstick off with a clean cloth.
-- Install the cap hand-tight, then remove it again and check the fluid level.
Fluid Level Is Only Valid If Screw Cap Has Been Screwed On.
Engine not running and front wheels in straight-ahead position.
-- Check the oil level.
Oil level must be located between lowest marking -arrow A- and the highest marking -arrow B- of dipstick.
Fluid must be drawn off if the level is above the specified range.
If fluid level is below specified range, hydraulic system must be checked for leaks. Refer to STEERING, CHECKING FOR LEAKS . It is not enough to just add fluid.
Do not use drained hydraulic oil.
-- If hydraulic system is properly sealed, fill hydraulic fluid.
-- Install the cap on the reservoir hand-tight.