Transmission Mount, Removing And Installing: Installing
Install in reverse order of removal and note the following:
Risk of damaging threads in transmission support by inserting bolts at an angle.
Replace the bolts that were tightened with an additional turn.
The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts -arrows 1-. Push the rear of the transmission upward using a floor jack if necessary.
Only remove the :10-222A when bolts for the subframe mount are tightened to tightening specification.
-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.
-- Install the bolts -3- for the transmission mount by hand all the way.
-- Align the transmission mount -1- with the transmission bracket -2- so that the distance -a- is the same and is at least 10 mm.
-- Remove the :10-222A from the engine.