Knock Sensor 1 -G61-, CHECKING

Function

The Knock Sensor 1 -G61- is a tuned accelerometer on the engine which converts engine vibration to an electrical signal. The Engine Control Module -J623- uses this signal to determine the presence of engine knock and to retard spark timing.

Special tools and workshop equipment required

Multimeter
Wiring Diagram
Scan Tool

Test requirements

Fuses OK.
Battery voltage OK.
Switch OFF all electrical and electronic accessories.
Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
Vehicles with Man. Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
Coolant Temperature: ≥ 80° C.
Observe all safety precautions. Refer to: SAFETY PRECAUTIONS .
View clean working conditions. Refer to: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to: PRELIMINARY CHECK . -- Was Complaint verified?	YES: GO TO Step 2 Knock Sensor 1 -G61-, CHECKING . NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Knock Sensor 1 -G61- harness connector. CHECK: Knock Sensor 1 -G61- component connector terminals 1 to 2 for resistance. SPECIFIED VALUE: 4500 Ω + / - 500 Ω. -- Was Value obtained?	YES: GO TO Step 3 Knock Sensor 1 -G61-, CHECKING . NO: REPLACE: Knock Sensor 1 -G61-. Refer to appropriate repair service information. GO TO: Step 4 Knock Sensor 1 -G61-, CHECKING .
3	REMOVE: Engine Control Module - J623-. Refer to appropriate repair service information. CHECK: Knock Sensor 1 -G61- harness connector terminals 1 to the Engine Control Module - J623- harness connector T60 / 39 for resistance. CHECK: Knock Sensor 1 -G61- harness connector terminals 2 to the Engine Control Module - J623- harness connector T60 / 54 for resistance. CHECK: Knock Sensor 1 -G61- harness connector terminals 3 to the Engine Control Module - J623- harness connector T60 / 52 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Were Values obtained?	YES: REPLACE: Engine Control Module -J623-. Refer to appropriate repair service information. GO TO: Step 4 Knock Sensor 1 -G61-, CHECKING . NO: CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 4 Knock Sensor 1 -G61-, CHECKING .
4	Final Procedure Perform a road test to verify repair. Do any DTC's return:	YES: Check the DTC memory. Refer to: DIAGNOSTIC MODE 03 - READ DTC MEMORY . Perform the diagnostic procedure for that DTC. NO: Repair is complete. Generate readiness code. Refer to: READINESS CODE . Return vehicle to Customer.