Checking Readiness Code Status (TT 01-15-01)
WARNING: This page is about the Touareg Hybrid, which is a different variant/trim than selected.
Publication date: 2015-06-26Reference number: TT 01-15-01
CHECKING READINESS CODE STATUS
TECH TIPS
Reference Number(s): TT 01-15-01, Date of Issue:
June 26, 2015
| VOLKSWAGEN: | 2012-2015 Passat, Touareg |
| GROUP: | 01 - On-Board Diagnostic (OBD) |
SERVICE INFORMATION
2012-2015 Passat, Touareg - Checking readiness code status
To check readiness code status, verify ODIS is at the latest software level and utilize the following:
From the control module list view, right click on the ECM and select Vehicle OBD. Then select OBD customer service. Left click on Mode 01: "Check current diagnostic data. PID 01"
See below for reference. You will have to click on each individual selection to verify status.
| Mode 01: Check current diagnostic data | |
|---|---|
| PID 01 - Monitoring status since erasing DTC memory | succeeded |
| [SO]_Param_DTCAndMILStatu | |
| Number of emission-relevant DTC memory entries | 0 |
| Malfunction indicator lamp | Off |
| [SO]_Param_SuppoStatuOfContiMonit | |
| Monitoring of ignition misfires | activated |
| Monitoring of fuel system | activated |
| Monitoring of entire system | activated |
| Monitoring of compression ignition | Supported |
| [SO]_Param_ComplStatuOfContiMonitSinceDTCsClear | |
| Ignition misfire test | completed successfully |
| Fuel system test | completed successfully |
| Entire system test | completed successfully |
| Intermittent monitoring | |
| [LO]_Support status of non-continuous monitors: compression ignition engines | |