Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT R134A | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Twelve-Point Bolt With Ribs | 70 Nm + 90° | ||
| Twelve-Point Bolt Without Ribs | 200 Nm + 180° | ||
| Battery | BATTERY, STARTER, GENERATOR, CRUISE CONTROL | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM, BLEEDING | ||
| Disc Brakes | FRONT BRAKES, FN 3 REAR BRAKES, CII 41 |
||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Charging | |||
| Generator | N/A | ||
| Torque |
N/A |
||
| Drive Belts | |||
| Adjustment | RIBBED BELT | ||
| Belt Routing | See fig. 26 under RIBBED BELT | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | 1.4 to 1.6 bar | ||
| Thermostat R & I | COOLANT THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE, CHECKING | ||
| Oil Pressure | -- Start the engine and increase the engine speed: The LED must illuminate at 1.2 to 1.6 bar. At 2000 RPM and an oil temperature of 80 °C (176 °F), the oil pressure must be between 2.0 and 4.5 bar. |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate Torque | 60 Nm + an additional 90° (1/4) turn | ||
| Fuel System | |||
| Pressure Specification | The fuel injection system is separated into a high pressure side, where the pressure is a maximum of approximately 120 bar and a low pressure side, where the pressure is approximately 6 bar. | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE RELEASE PROCEDURE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | TECHNICAL DATA AND SPARK PLUGS | ||
| Starting | |||
| Starter | N/A | ||
| Torque | N/A | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFIED VALUES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | FWD: 140 Nm AWD: 120 Nm |
||