Checking Activation
-- Remove the Engine Control Module -J623-.
-- Using a Multimeter, Check the Camshaft Position (CMP) Sensor -G40- electrical harness connector to the Engine Control Module -J623- electrical harness connector T60 for an open circuit.
| Camshaft Position (CMP) Sensor -G40- electrical harness connector terminals: | Engine Control Module - J623 - electrical harness connector T60 terminals: |
|---|---|
| 2 | 6 |
Specified value: 1.5 Ω Max.
If the specified value was Not obtained:
-- Check the wiring connection for an open circuit, short circuit to Battery positive or Ground
-- Check the wiring connection for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
-- Go to Final procedures
If the specified value was obtained:
-- Replace the Camshaft Position (CMP) Sensor -G40-.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
- Check the DTC memory DIAGNOSTIC MODE 03 - READ DTC MEMORY .
- If necessary, erase the DTC memory DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
- If the DTC memory was erased, generate readiness code READINESS CODE .