Wiper Motor Control Module -J400-, DEACTIVATING APP

The windshield wiper system is equipped with the APP function (alternating park position).

The APP function causes the wiper at every second shut off to move upward slightly after reaching the lowest position.

To install the motor crank on the Windshield Wiper Motor -V-, it is necessary to shut off the Windshield Wiper Motor -V- in the lower park position. This is attained by deactivating the APP function.

Note the following: 

• An activation of APP function is not possible.
• APP function is automatically activated after 100 wiping cycles. This applies to Windshield Wiper Motors -V- in which the APP function was deactivated as well as new Windshield Wiper Motors -V-.

Procedure 

-- Connect the Vehicle Diagnostic Tester.

-- Select Guided Fault Finding  .

-- Use the GO TO  button to select the "function/component selection" and the following menu options one after the other:

• Body
• Electrical Equipment
• 01 - OBD-capable systems
• 09 - vehicle electrical system control module
• Vehicle electrical system control module functions
• Coding the wiper motor control module/deactivating the APP function