Test sequence (vehicles with engine code AFP): Notes

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Three-Wire Hall Camshaft Position Sensor G40 - Disconnect

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect the 3-pin connector from Camshaft Position (CMP) Sensor -G40- (arrow).

Checking voltage supply

Fig 2: Measuring Voltage Between Terminal 1 And 3 Of Camshaft Position Sensor Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect multimeter to terminal 1 (B+) and 3 (Ground -GND-) of connector for Camshaft Position (CMP) sensor for voltage measurement.
Switch ignition on.

Specified value: at least 4.5 V

Switch ignition off.

If there is no voltage:

Check wires to Engine Control Module (ECM) according to wiring diagram. Refer to Checking wires to Engine Control Module (ECM) .