Controls, Housing - Rear Final Drive

• 34 Controls, Housing
  • General Information
    • Transfer Case Transporting
    • Transfer Case Gear Oil Level, Checking
  • Description And Operation
    • Electrical And Electronic Components And Locations
    • Transfer Case Assembly Overview
    • Transfer Case Breather Line Routing
  • Specifications
    • Fastener Tightening Specifications
  • Removal And Installation
    • Differential Control Module
    • Differential Motor
      • Notes
      • Removing
        • If The Differential Motor -V253- Is Replaced, Observe The Following
        • Continuation For All
      • Installing
        • Notes
        • Transfer Case Operating Unit -E473- Is In "Low" Position (Fig. A)
        • Transfer Case Operating Unit E473 Is Not In "Low" Position (Fig. B)
    • Front Driveshaft Output Flange Seal, With Transfer Case Installed
      • Notes
      • Remove The Output Flange Nut
      • Lubricate New O-Ring -Arrow- With Gear Oil And Insert
      • Tighten New Nut For Output Flange To Specification
      • Secure Nut At Intended Points -Arrows- (E.G., With A Drift)
    • Rear Driveshaft Output Flange Seal, With Transfer Case Installed
      • Notes
      • Remove Output Flange Nut.
      • Lubricate New O-Ring -Arrow- With Gear Oil And Insert.
      • Tighten New Nut For Output Flange To Specification.
      • Secure Nut At Intended Points -Arrows- (E.G., With A Drift).
    • Transmission Carrier And Bracket
      • Notes
      • Tightening Specifications
    • Transmission Carrier Bonded Rubber Bushings
    • Transfer Case
      • Notes
      • If Equipped, Install Vibration Damper -A- To Transfer Case And Tighten Bolts -B-
    • Driveshaft Output Flange And Differential Motor Seals, With Transfer Case Removed
    • Input Shaft Seal
  • Special Tools