Test-ID $05 (05): Tank Ventilation System, Tank Leak Test

End of diagnosis.
Connect the scan tool.
Start the engine and run at idle.
Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Test-ID $05 (05)".

Test-ID (TID) (Hex-ID)	DTC	Component or System	Min.	Max.	Additional Information
0D ($13)	P0455	Fuel Tank Leak Test. For additional information, refer to the Bosch Motronic ME 7.5 OBD System Strategy. Page 17.		1.1 Seconds	Refer to DTC P0455 in the DTC summary table. Additional exhaust regulation .
0D ($13)	P0442	Pressure Check. For additional information, refer to the Bosch Motronic ME 7.5 OBD System Strategy. Page 17.		3.0 Seconds	Refer to DTC P0442 in the DTC summary table. Additional exhaust regulation .
0E ($14)	P1475	Rationality Check. For additional information, refer to the Bosch Motronic ME 7.5 OBD System Strategy. Page 17.		Contact unable to close, signal always low.	Refer to DTC P1475 in the DTC summary table. Engine .
0F ($15)	P1476	Rationality Check. For additional information, refer to the Bosch Motronic ME 7.5 OBD System Strategy. Page 17.		Contact unable to open, signal always high.	Refer to DTC P1476 in the DTC summary table. Engine .

If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure → Mode 03: Interrogating fault memory .
Switch the ignition off.
End of diagnosis.