LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 1981 >> Rabbit Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> Wheel Alignment (Procedures) >> VOLKSWAGEN >> Adjustment >> Camber >> Dasher (Front)

Dasher (Front)

If camber is not within specifications, loosen nuts attaching ball joint to track control arm. To adjust, insert adjusting tool (40-200) in adjusting holes in control arm and pry ball joint sideways until camber is set to specifications. Tighten attaching nuts and recheck camber. Camber should not vary more than 1° between right and left sides.

NOTE: Insert tool from front on right side and from rear on left side.
scientia non olet · About LEMON Manuals