Operating Conditions
| Enable Criteria | ECU On |
| Failure Criteria | EEPROM Write/Read Fail, CRC Error is detected Failure is detected if Error flag is set over 5 times 2) ROM/RAM Error Occur - ECC detect function is used for ROM/RAM error detection Failure is detected if Error flag is set over 5 times 3) MCU Trap Occur - MCU Trap module is used Failure is detected if Error flag is set over 5 times 4) Stack Over Flow Occur - Failure is detected if the stack pointer is pointing out of the address defined available stack range 5) Cycle Time Over Occur - In case that the program execution time of Task 5 ms exceeds more than 10% of the loop time 10 times - In case that the program execution time of Task 1 ms exceeds more than 0% of the loop time 20 times 6) ADC Converter Error Occur - Failure is detected if ADC is not completed 7) Oscillator Error Occur - Failure is detected in case of oscillator failure while initializing the clock 8) PFM Error - PFM error occurs more than 5 times 9) MPU Error - MPU error occurs more than 5 times 10) MCU VCC 3.3V detection - VCC Error occurs more than 30 times continuously 11) ASIC related error occurred - ASIC power, oscillator, nvm, spi and current error occurred more than 100 ms continuously 12) Core0/2 Stuck monitoring - Core0/2 stuck is occurred more than 4 times 13) Rom Check Logic, - Check the consistency of flashed binary on IGN On. - Rom Check Logic is Application/Calibration Data Consistency Check. It can be seen that the detection is Application/calibration not programmed. - Failure is detected if Error flag is set over 2 times |
| Failure/Mature Time | See Test Failed criteria/Confirmation Failure criteria |
| Pass Criteria | Ignition Re-On |
| Pass/De-mature Time | Immediate. |
| Failure Aging | 40 Ignition cycles. |