Control Arm: Installation
Press in new bushings, if old were removed. To install control arm, reverse removal procedure. Do not tighten control arm pivot bolts until weight of vehicle is on rear wheels. Bleed brake system.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (mkg) | |
|---|---|---|
| Shock Absorber-to-Chassis | 50-65 (6.9-9.0) | |
| Shock Absorber-to-Link | 34-46 (4.7-6.4) | |
| Shock Absorber Link-to-Control | ||
| Arm | 15-20 (2.0-2.8) | |
| Axle-to-Differential Flange | 26-34 (3.6-6.4) | |
| Control Arm Pivot Bolts | 38-46 (5.5-6.4) | |
| Control Arm Mounts-to-Chassis | 26-34 (3.6-4.7) | |
| Control Arm-to-Bearing Carrier | 11-16 (1.5-2.2) | |