Installation [12/2022 - ]: Procedure

NOTE: Do not twist the front speed sensor wire harness when installing it.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the front speed sensor to the steering knuckle with the bolt.

      Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

      NOTE:

      • Keep the tip of the front speed sensor and installation hole free of foreign matter.
      • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.
      • After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.
   2. Engage the clamp to the front shock absorber assembly.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Hook

   -

   -

   1. Engage the 2 hooks to the front shock absorber assembly.
   2. Install the front speed sensor clamp and front flexible hose to the front shock absorber assembly with the bolt.

      Torque: 29 N.m (296 kgf/cm, 21 ft.lbf) 

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Hook

   -

   -

   1. Engage the hook to the vehicle body.
   2. Install the front speed sensor with the 2 bolts.

      Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

4. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Engage the 2 clamps to the vehicle body.
   2. Connect the connector.

Refer to INSTALLATION [12/2022 - ]

Refer to INSTALLATION [12/2022 - ]

Refer to SIGNAL CHECK [12/2022 - ]