Installation [11/2021 - 05/2022]: Procedure
- INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Bolt
Torque: 21 N.m (214 kgf/cm, 15 ft.lbf)
Nut
Torque: 5.6 N.m (57 kgf/cm, 50 in.lbf)
- INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
Bolt
Torque: 21 N.m (214 kgf/cm, 15 ft.lbf)
Nut
Torque: 5.6 N.m (57 kgf/cm, 50 in.lbf)
- INSTALL DIFFERENTIAL TORSIONAL DAMPER RH (for RH Side)
Refer to PROCEDURE - Step 3
- INSTALL REAR WHEEL (for RH Side)
Refer to PROCEDURE - Step 1
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to INSTALLATION [11/2021 - ]
- INSPECT VEHICLE HEIGHT NOTE:
If the height control sensor link is removed, check the vehicle height.
Refer to ADJUSTMENT [11/2021 - ]
- ADJUST VEHICLE HEIGHT NOTE:
If the height control sensor has been replaced, be sure to adjust the vehicle height.
Refer to ADJUSTMENT [11/2021 - ]
- PERFORM CALIBRATION
Refer to REMOVAL [11/2021 - 05/2022]
- INSPECT HEADLIGHT AIMING
Refer to ADJUSTMENT [11/2021 - ]
- INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.