Installation [04/2018 - ]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL KNOCK CONTROL SENSOR
HINT:
Perform "Inspection After Repair" after replacing the knock control sensor.
Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
*a Top *b Right of Vehicle *c 15° *d 5° NOTE:- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
- Connect the knock control sensor connector.
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [04/2018 - 08/2021] , or refer to INSTALLATION [08/2021 - ]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the knock control sensor.
Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Perform "Inspection After Repair" after replacing the knock control sensor.