Installation [04/2018 - ]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NO. 2 ECM BRACKET
- Install the No. 2 ECM bracket to the ECM with the 2 screws.
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- Install the No. 2 ECM bracket to the ECM with the 2 screws.
- INSTALL NO. 1 ECM BRACKET
- Install the No. 1 ECM bracket to the ECM with the 2 screws.
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- Install the No. 1 ECM bracket to the ECM with the 2 screws.
- INSTALL ECM
- Install the ECM with the 2 nuts in the order shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTE:If the ECM has been struck or dropped, replace it.
- Engage the clamp.
- Install the engine wire to the No. 2 ECM bracket with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the 2 ECM connectors and rotate the 2 levers to lock them.NOTE:
- When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water and other foreign matter.
- Be sure to securely connect the ECM connectors.
- Install the ECM with the 2 nuts in the order shown in the illustration.
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 3
- PERFORM INITIALIZATION
Refer to PRECAUTION [04/2018 - 08/2020] , or refer to PRECAUTION [08/2020 - 08/2021] , or refer to PRECAUTION [08/2021 - ]