Installation [08/2015 - ]: Procedure

1. Install the 2 sensor clamps with the 2 bolts.

   Torque: 13 N.m (127 kgf/cm, 9 ft.lbf) 

   NOTE:

   Make sure the clamp rotation stopper touches the installation position.

2. Connect the connector.
   NOTE:

   Securely connect the connector.

3. Attach the connector.
4. Attach the 8 clamps.
   NOTE:

   When attaching the clamps, do not twist the wire harness.

1. Install the speed sensor with the nut.

   Torque: 7.8 N.m (80 kgf/cm, 69 in.lbf) 

   NOTE:

   • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
   • While inserting the speed sensor into the axle hole, do not strike or damage the sensor tip.
   • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle.
   • Make sure there is no foreign matter attached to the speed sensor rotor.
2. Connect the speed sensor connector.
   NOTE:

   Securely connect the connector.

HINT: 

Use the same procedure described for the LH side.

Refer to PROCEDURE - Step 3

1. Check the speed sensor signal (Refer to TEST MODE PROCEDURE [08/2015 - 08/2019] , or refer to TEST MODE PROCEDURE [08/2019 - ] ).