LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Mirai >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Front Camera System - Diagnostic Codes) >> Front Camera System >> DTC U0300-51: Internal Control Module Software Incompatibility Not Programmed [11/2018 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2020 Toyota Mirai and 2019 Toyota Mirai. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
  • If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

    HINT: 

    Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

    One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [11/2018 - ]

    Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [11/2018 - ]

scientia non olet · About LEMON Manuals