Inspection [06/2016 - ]: Procedure

INSPECT PATTERN SELECT SWITCH ASSEMBLY

Make sure that there is no looseness in the locking part and the connecting part of the VSC OFF switch.

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*a	Component without harness connected (Pattern Select Switch Assembly)

Standard Resistance

Tester Connection	Check Condition	Specified Condition
5 - 8	Switch not pushed in	10 kΩ or higher
5 - 8	Switch pushed in	Below 1 Ω

Make sure that there is no looseness in the locking part and the connecting part of the TRACK switch.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Check Condition	Specified Condition
1 - 8	Switch not pushed in	10 kΩ or higher
1 - 8	Switch pushed in	Below 1 Ω

Check the illumination status

Check the illumination when the battery voltage is applied between the connector terminals.

Standard

Check Condition	Specified Condition
Battery positive → 2 Battery negative → 3	The illumination comes on