Installation [06/2016 - ]: Procedure

1. Install the rear speed sensor LH with the 3 bolts.

   Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) 

   NOTE:

   Prevent foreign matter from attaching to the rear speed sensor LH tip, installation surface and sensor body.

2. Connect the 2 harness clamps.
   NOTE:

   Do not twist the wire harness for the rear speed sensor LH when installing it.

3. Pull the rear speed sensor LH grommet out from vehicle interior.
   NOTE:

   • Do not pull the rear speed sensor LH wire harness.
   • Do not fix the pass-through grommet at an angle.
4. Connect the rear speed sensor LH connector.
5. Install the luggage compartment floor mat.

Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

(Refer to TEST MODE PROCEDURE [06/2016 - ] )