Installation [11/2015 - ]: Procedure

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the rear axle hub and bearing assembly (Refer to PROCEDURE - Step 1 ).
  HINT:
  - The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
  - If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
INSPECT REAR AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 5
INSPECT REAR AXLE HUB RUNOUT
Refer to PROCEDURE - Step 6
INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
Refer to PROCEDURE - Step 8

CONNECT SKID CONTROL SENSOR WIRE

Install the skid control sensor wire connector to the connector cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002.

Engage the 3 claws to secure the connector cover.

Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.

INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
1. Connect the cable to the negative (-) auxiliary battery terminal (Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2 ).
2. Connect the reservoir level switch connector.
3. Clear the DTCs (Refer to DTC CHECK / CLEAR [11/2015 - ] ).
INSPECT REAR WHEEL ALIGNMENT
(Refer to INSPECTION [11/2015 - 06/2017] , or refer to INSPECTION [06/2017 - ] )
CHECK FOR SPEED SENSOR SIGNAL
(Refer to TEST MODE PROCEDURE [11/2015 - ] )