Installation [11/2015 - ]: Procedure

1. Install the front speed sensor onto the steering knuckle with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   • Check that the front speed sensor tip and installation portion are free of foreign matter.
   • Install the front speed sensor without turning it from its original installation angle.
2. Install the No. 1 clamp onto the shock absorber with the bolt and front flexible hose.

   Torque: 29 N*m (300 kgf*cm, 22 ft.*lbf) 

3. Install the No. 2 clamp onto the body with the bolt.

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

4. Engage the 2 clamps onto the body.
5. Install the No. 3 clamp onto the body.
6. Connect the front speed sensor connector.
7. Engage the clamp onto the body.

HINT: 

Use the same procedure for the LH side and RH side (Refer to PROCEDURE - Step 4 ).

(Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2 )

(Refer to TEST MODE PROCEDURE [11/2015 - ] )