Installation [08/2015 - 08/2019]: Procedure

INSTALL POWER MANAGEMENT CONTROL ECU
1. Attach the 2 claws to install the power management control ECU.
INSTALL ECU INTEGRATION BOX RH
1. Install the ECU integration box RH with the 2 nuts and bolt.
2. Attach the clamp.
3. Connect all the connectors.
  NOTE:
  - Do not twist the connectors of the ECU when connecting them.
  - Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.
INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
INSTALL INSTRUMENT PANEL BOX DOOR COVER
Refer to PROCEDURE - Step 15
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL LOWER INSTRUMENT COVER LH
Refer to PROCEDURE - Step 17
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 18
INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
HINT:

Use the same procedure described for the No. 1 instrument cluster finish panel garnish.
1. Install the No. 2 instrument cluster finish panel garnish (Refer to PROCEDURE - Step 8 ).
INSTALL COWL SIDE TRIM BOARD RH
1. Attach the clip and claw to install the cowl side trim board.
2. Install the clip.
INSTALL DOOR SCUFF PLATE ASSEMBLY RH
1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (Refer to CHECK MODE PROCEDURE [08/2015 - ] ).