LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> 4Runner TRD Pro >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System - Service Information >> Front Speed Sensor >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

  1. INSTALL FRONT SPEED SENSOR 
    1. Install the speed sensor with the bolt.

      Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

      NOTE:
      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
      • Make sure there is no foreign matter attached to the speed sensor rotor.
  2. INSTALL SKID CONTROL SENSOR CLAMP 
    1. Install the skid control sensor clamp with the bolt.

      Torque: 13 N.m (127 kgf/cm, 9 ft.lbf) 

      NOTE:

      Install the clamp so that the rotation stopper touches the knuckle.

  3. INSTALL FRONT SKID CONTROL SENSOR WIRE 
    1. Connect the connector as follows.
      1. for LH:

        1. Attach the connector, and then connect the connector.

        NOTE:

        Securely connect the connector.

      2. for RH:

        1. Install the skid control sensor clamp with the bolt.

        Torque: 5.0 N.m (51 kgf/cm, 44 in.lbf) 

        NOTE:

        Make sure the clamp rotation stopper touches the installation position.

        2. Attach the connector, and then connect the connector.

        NOTE:
        • Securely connect the connector.
        • When connecting the connector, do not twist the wire harness.

        3. Attach the clip.

    2. Install the 2 harness clamps with the 2 bolts.

      Torque: 13 N.m (127 kgf/cm, 9 ft.lbf) 

      NOTE:
      • When installing the clamps, do not twist the wire harness.
      • Make sure the clamp rotation stopper touches the installation position.
    3. Install the 2 harness clamps with the 2 bolts.

      Torque: 13 N.m (127 kgf/cm, 9 ft.lbf) 

      NOTE:
      • When installing the clamps, do not twist the wire harness.
      • Make sure the clamp rotation stopper touches the installation position.
    4. Attach the clip.
    5. Connect the connector.
      NOTE:

      Securely connect the connector.

  4. INSTALL FRONT WHEEL 

    Refer to PROCEDURE - Step 14

  5. CHECK SPEED SENSOR SIGNAL 
    1. Check the speed sensor signal (Refer to TEST MODE PROCEDURE [08/2015 - 08/2019] , or refer to TEST MODE PROCEDURE [08/2019 - ] ).
scientia non olet · About LEMON Manuals