Inspection [08/2016 - ]: Procedure
- INSPECT STEERING HEATER SWITCH
- Disconnect the steering heater switch connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 (IG) - 1 (B) Steering heater switch is pushed Below 1 Ω 4 (IG) - 1 (B) Steering heater switch is not pushed 10 kΩ or higher If the result is not as specified, replace the steering heater switch.
*a Component without harness connected
(Steering Heater Switch)