Battery Blower: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL BATTERY COOLING BLOWER ASSEMBLY (for RH Side)
NOTE:
- Be sure not to touch the fan part of the battery cooling blower assembly.
- Do not lift the battery cooling blower assembly using the wire harness.
1. When replacing the battery cooling blower assembly (for RH side) with a new one:
  1. Connect the clamp to the battery cooling blower assembly (for RH side).
    
    Fig 1: Identifying Clamp
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the battery cooling blower assembly with the 3 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
3. Connect the connector and clamp.
INSTALL BATTERY COOLING BLOWER ASSEMBLY (for LH Side)
NOTE:
- Be sure not to touch the fan part of the battery cooling blower assembly.
- Do not lift the battery cooling blower assembly using the wire harness.
1. When replacing the battery cooling blower assembly (for LH side) with a new one:
  1. Connect the clamp to the battery cooling blower assembly (for LH side).
    
    Fig 2: Identifying Clamp
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the battery cooling blower assembly with the 3 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
3. Connect the connector and clamp.
INSTALL REAR DECK TRIM COVER . Refer to INSTALLATION - Step 21
INSTALL DECK TRIM SERVICE HOLE COVER . Refer to INSTALLATION - Step 22
INSTALL DECK FLOOR BOX LH
HINT:

Use the same procedure described for the RH side.
INSTALL REAR NO. 4 FLOOR BOARD SUB-ASSEMBLY . Refer to INSTALLATION - Step 27
INSTALL DECK FLOOR BOX RH . Refer to INSTALLATION - Step 54
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 55
INSTALL REAR NO. 2 FLOOR BOARD . Refer to INSTALLATION - Step 56