Data List / Active Test

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Enter the following menus: Chassis / PPS / Data List.
6. According to the display on the Techstream, read the Data List.
   PPS
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Steering Angle Velocity	Steering angle speed/ Min.: -32768 deg/s Max.: 32767 deg/s	Value changes in proportion to steering effort	The engine is running and the steering wheel is being turned.
   Meter Vehicle Velocity	Vehicle speed from meter/ Min.: 0.00 km/h (0.00 mph) Max.: 300.00 km/h (186.41 mph)	0 km/h (0 mph)	The vehicle is stopped.
   		No large fluctuation	The vehicle is driven at a constant speed.
   Engine Revolution	Engine speed/ Min.: 0 rpm Max.: 12800 rpm	No large fluctuation	The engine is running at a constant speed.
   Steering Angle	Steering angle/ Min.: -2048.0 deg Max.: 2047.0 deg	Left turn: Increases Right turn: Decreases	The engine is running and the steering wheel is being turned.
   Solenoid Current	Solenoid Current/ Min.: 0 mA Max.: 1000 mA	200 to 950 mA	The engine is running and the steering wheel is being turned.
   IG Power Supply	ECU power source voltage/ Min.: 0.0 V Max.: 25.5 V	11 to 14 V	The ignition switch is ON.