Pre-Collision Brake Cancel Switch: Inspection: Inspection

INSPECT PRE-COLLISION BRAKE CANCEL SWITCH ASSEMBLY

Fig 1: Inspecting Pre-Collision Brake Cancel Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check the resistance of the pre-collision brake cancel switch.

TEXT IN ILLUSTRATION

*a	Component without harness connected (Pre-collision Brake Cancel Switch Assembly)

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
1 - 2	on (Pressed)	Below 1 Ω
1 - 2	off (Not pressed)	10 kΩ or higher

If the result is not as specified, replace the pre-collision brake cancel switch.