DTC C1420: Acceleration Sensor Malfunction: Procedure

1. Confirm whether the vehicle is w/ VDIM or w/o VDIM.
   RESULT
   
   

   Result	Proceed to
   w/ VDIM	A
   w/o VDIM	B

B → See step   3 

A: Go to next step 

1. Check that the yaw rate and acceleration sensor has been installed properly. Refer to INSTALLATION .

   OK

   The sensor is tightened to the specified torque.

   The sensor is not installed in a tilted position.

   NOTE:

   Check the yaw rate and acceleration sensor signal after replacement. Refer to TEST MODE PROCEDURE .

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .

NG → See step   5 

OK → See step   4 

1. Check that the brake actuator assembly has been installed properly. Refer to INSTALLATION .

   OK

   The brake actuator assembly is tightened to the specified torque.

   The brake actuator assembly is not installed in a tilted position.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .

NG → See step   7 

OK → See step   6