LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Base, 3.5L Eng VIN K, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Service Information) (2GR-FE) >> Crankshaft Position Sensor >> Removal >> Removal

Crankshaft Position Sensor: Removal: Removal

  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM  . Refer to REPLACEMENT - Step 1
  2. REMOVE V-BANK COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 25
  3. REMOVE ENGINE UNDER COVER ASSEMBLY  . Refer to REMOVAL - Step 7
  4. REMOVE NO. 1 ENGINE UNDER COVER  . Refer to REMOVAL - Step 8
  5. DRAIN ENGINE COOLANT  . Refer to REPLACEMENT - Step 4
  6. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 1
  7. REMOVE BATTERY  . Refer to REMOVAL - Step 2
  8. REMOVE NO. 2 AIR CLEANER INLET  . Refer to REMOVAL - Step 3
  9. REMOVE NO. 1 AIR CLEANER INLET  . Refer to REMOVAL - Step 4
  10. DISCONNECT NO. 1 RADIATOR HOSE  . Refer to REMOVAL - Step 9
  11. DISCONNECT NO. 2 RADIATOR HOSE  . Refer to REMOVAL - Step 10
  12. DISCONNECT OIL COOLER HOSE  . Refer to REMOVAL - Step 11
  13. DISCONNECT COOLING FAN ECU CONNECTOR  . Refer to REMOVAL - Step 12
  14. REMOVE RADIATOR GRILLE SUB-ASSEMBLY  . Refer to REMOVAL - Step 2
  15. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)  . Refer to REMOVAL - Step 5
  16. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)  . Refer to REMOVAL - Step 6
  17. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY  . Refer to REMOVAL - Step 16
  18. SEPARATE COOLER CONDENSER ASSEMBLY  . Refer to REMOVAL - Step 17
  19. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR  . Refer to REMOVAL - Step 18
  20. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY  . Refer to REMOVAL - Step 4
  21. DISCONNECT SUCTION HOSE SUB-ASSEMBLY  . Refer to REMOVAL - Step 5
  22. REMOVE COMPRESSOR AND MAGNETIC CLUTCH  . Refer to REMOVAL - Step 6
  23. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
      Fig 1: Identifying Crankshaft Position Sensor Bolt
      GTY133135Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and crankshaft position sensor.
scientia non olet · About LEMON Manuals