How To Proceed With Troubleshooting

HINT: 

• Use the following procedure to troubleshoot the power window control system.
• Techstream should be used in steps 4 and 6.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS CHECK 
   • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
   • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
   • The following 5 items are important points in the problem analysis:

     What	Vehicle model, system name
     When	Date, time, occurrence frequency
     Where	Road conditions
     Under what conditions?	Driving conditions, weather conditions
     How did it happen?	Problem symptoms

   NEXT: Go to next step 

3. INSPECT BATTERY VOLTAGE 
   1. Measure the battery voltage.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT: Go to next step 

4. CHECK FOR DTC 
   1. Check for DTCs and note any codes that are output. Refer to DTC CHECK / CLEAR .
   2. Delete DTCs.
   3. Recheck for DTCs.

      Result

      Result	Proceed to
      No DTCs output	A
      DTCs output	B Refer to DIAGNOSTIC TROUBLE CODE CHART

      B → GO TO DIAGNOSTIC TROUBLE CODE CHART 

      A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → GO TO STEP   7 

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Data List/Active Test. Refer to DATA LIST / ACTIVE TEST 
   2. Circuit inspection
   3. Terminal of ECU. Refer to TERMINALS OF ECU 

      NEXT: Go to next step 

7. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

8. RESET POWER WINDOW MOTOR 

   HINT: 

   Refer to INITIALIZATION .

   NEXT → END