DTC 43: ABS Control System Malfunction: Procedure

1. Clear the DTC. Refer to DTC CHECK / CLEAR .
2. Turn the ignition switch to the ON position.
3. Check if the same DTC is recorded. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC (ABS control system DTC) is not output	A
   DTC (ABS control system DTC) is output	B

B → See step   3 

A: Go to next step 

1. Turn the ignition switch off.
2. Clear the DTC. Refer to DTC CHECK / CLEAR .
3. Start the engine.
4. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.
5. Check if the same DTC is recorded. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC (43) is not output	A
   DTC (43) is output	B

B → REPLACE BRAKE ACTUATOR ASSEMBLY 

A → CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)