LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> RAV4 Base, 2.5 F, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control (Service Information) >> Steering Angle Sensor >> Installation >> Installation

Steering Angle Sensor: Installation: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the holes of the sensor with the pins on the spiral cable, and attach the 6 claws to install the sensor to the spiral cable.
      Fig 1: Identifying Steering Angle Sensor Claws
      GTY243509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 9
  3. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION - Step 10
  4. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 11
  5. INSTALL STEERING PAD ASSEMBLY  . Refer to INSTALLATION - Step 1
  6. INSPECT STEERING WHEEL CENTER POINT 
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When reconnecting the cable to the negative (-) battery terminal after installing the steering angle sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative (-) battery terminal.

  8. INSPECT STEERING PAD ASSEMBLY  . Refer to INSTALLATION - Step 3
  9. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .
scientia non olet · About LEMON Manuals