LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> Matrix Base, Standard >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Steering System (Diagnostics - Introduction) >> Power Steering System >> DTC Check/Clear >> DTC Check/Clear

DTC Check/Clear

  1. CHECK DTC 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis/EMPS/Trouble Codes. Read the DTCs by following the display on the Techstream.
    6. Check the details of the DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART .
  2. CLEAR DTC 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis/EMPS/Trouble Codes. Clear the DTCs by following the display on the Techstream.
    6. Clear the DTCs.
    7. Turn the ignition switch off.
    8. Disconnect the Techstream from the DLC3.
scientia non olet · About LEMON Manuals