Section 32 (Charging System (2AZ-FE) (Service Information)): Generator: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT . Refer to REMOVAL - Step 2
REMOVE GENERATOR ASSEMBLY
1. Remove the terminal cap.
  
  Fig 1: Identifying Terminal Cap, Nut, Generator Connector And Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut and disconnect the wire harness from terminal B.
3. Disconnect the generator connector and 2 harness clamps.
4. Remove the 2 bolts and generator assembly.
  
  Fig 2: Locating Generator Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and wire harness clamp bracket.
  
  Fig 3: Locating Wire Harness Clamp Bracket With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002