LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> Highlander SE, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FE) (Service Information) (Except Hybrid) >> Active Control Engine Mount >> Inspection >> Inspection

Active Control Engine Mount: Inspection: Inspection

  1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY 
    1. Disconnect the vacuum hose from the front engine mounting insulator assembly.
    2. Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 25 in.Hg) and wait for 1 minute.
      Fig 1: Identifying Vacuum Pump & Front Engine Mounting Insulator Assembly
      GTY179000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Check that there is no change in the needle movement of the vacuum pump gauge.

      OK

      Vacuum pressure holds.

    4. Check that there is no fluid leakage caused by a break in the diaphragm.
    5. Reconnect the vacuum hose.
scientia non olet · About LEMON Manuals