Front Axle Hub Bolt: Installation

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

INSTALL FRONT AXLE HUB BOLT LH
1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
2. Using a screwdriver or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
3. Remove the 2 temporary nuts.
  HINT:
  
  A plate washer of 5 mm (0.21 in.) or more in thickness is preferable.
INSTALL FRONT DISC
HINT:

Align the matchmarks of the front disc and front axle hub before installing them.
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

Fig 1: Installing Front Axle Hub Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002